Connect to customer computer and confirm surfing

Figure 30: ACP passes; select Exit

1.Disconnect the USB cable from the installer’s PC.

2.Connect the receive modem to the Gateway using the USB cable supplied with the unit. See Figure 31.The DW4020 will re-initialize and come back up in normal mode.

3.Connect the receive coaxial cable to the receive modem and the transmit coaxial cable to the transmit modem. See Figure 31.

4.Plug the power cord into the wall outlet or surge protector.

5.Make sure that the READY LEDs on all three units are STEADY GREEN. Make sure the transmit and receive cables are clearly labeled at the connectors.

6.The DW4020 is now commissioned. Connect the customer’s computer and the Gateway with Ethernet cable. See Figure 31. If the computer has a functioning and properly configured Ethernet interface, it will surf the Internet. If the customer cannot surf, see the instructions below.

30

Chapter 2 • Installing the indoor equipment 1031484-0001 Revision 2

Page 42
Image 42
Hughes DW4020 manual Connect to customer computer and confirm surfing, ACP passes select Exit