Hughes manual Installing the system using a modem, Installing the DW4020 Manually, on page

Installing the system using a modem

You need all the items shown in Figure 6. Some of them are in the modem installation kit or inside the antenna box.

If you are using Web commissioning, you must provide an Ethernet cable to connect between the DW4020 and installer PC.

If Web commissioning is not available, you must provide a 9-pin female/female (F/F) null modem serial cable. The serial cable can be used to configure the DW4020 via the serial port. Appendix C

–Installing the DW4020 Manually, on page 77.

You will also need the installation work order. This is provided to you by HNS.

Note: At some installation sites, the USB cable that comes with the DW4020 may not be long enough to reach from the installer PC to the DW4020. You may need a long USB cable.

Read this manual and obtain serial cable and installation work order
manual			Spec
This	9-pin F-F serial cable
			Install
Installation manual			Install specification
	Ethernet cable
These items are packaged in a small box inside your antenna box
			Clips
	Receive modem
	Transmit modem
	Gateway		AC cord
		DC cord
25-pin connector cable	USB cable	Power adapter	Power supply
			1031105-0001

Figure 6: Items required for installation

Chapter 2 • Installing the indoor equipment 1031484-0001 Revision 2

11