
Connect Ethernet, power up, and read the Gateway LED display
Installer laptop PC |
|
Ethernet port | AC power |
| cord |
Ethernet cable |
|
| USB cable |
Receive |
|
modem |
|
Transmit |
|
modem | Power |
| |
| supply |
Gateway |
|
| DC power |
| cord |
Figure 12: Connect power cord
After you assemble the DW4020, connect it to the installer laptop with Ethernet cable. Plug it into a 110 V wall outlet, power strip, or surge protector. The Gateway LED display will cycle. The cycle completes in less than a minute and follows this sequence:
•Gateway STATUS LED is red until the
•Gateway READY LED blinks green because it is not yet commissioned.
•Gateway STATUS LED blinks orange as it is not attached to the receive modem.
Note: In countries outside North America, the DW4020 may be plugged, with a physical adapter, directly into a 220 V outlet. Different countries may have different standards and requirements.
Note: Whenever the LEDs do not function properly as described below, check to be sure you have the correct power supply, PN
Chapter 2 • Installing the indoor equipment 1031484-0001 Revision 2
17