Motorola T1/E1 Accessing the CLI using a PC + HyperTerminal, Procedure 6 Configuring serial port

Canopy T1/E1 Multiplexer	September 2004
	T1/E1 Multiplexer FPGA Version 3.4

2.3.3Accessing the CLI using a PC + HyperTerminal

The Command Line Interface (CLI) is accessed using a PC with that includes a terminal emulation package such as HyperTerminal®.

NOTE: The device is only accessible through the serial port.

2.3.4Configuring the Canopy T1/E1 Multiplexer using the CLI

Before you use the CLI to configure the Canopy T1/E1 Multiplexer, you must configure the PC serial port.

Procedure 6: Configuring serial port

Use this procedure to access the CLI using a terminal emulation program such as HyperTerminal.®

1.Connect the serial cable from the DB9 serial port on a PC to the Serial port on the Canopy T1/E1 Multiplexer. The DB9 connector on Canopy T1/E1 Multiplexer is female; the cable from the PC is male. A straight-through cable is required.

2.Start HyperTerminal or another terminal emulation program.

3.Set the terminal emulation program to emulate a VT100 terminal with the following settings:

Parameter	Value
Bits per second	19200
Data bits	8
Parity	none
Stop bits	1
Flow control	none

4.Press Enter.

The Canopy T1/E1 Multiplexer Login menu is displayed. RESULT: The signal port is configured.

end of procedure

To use the CLI, select Command Line Interface terminal from the File drop-down menu (illustrated in Figure 14 on Page 33). The Command Line Interface window opens, as shown in Figure 16.

Issue 3 Page 34 of 73