Canopy T1/E1 Multiplexer

September 2004

 

T1/E1 Multiplexer FPGA Version 3.4

2.4.5Configure Ports

Procedure 10: Configuring the Ethernet ports using the CLI

Perform this procedure to configure the Ethernet ports using the CLI manager.

NOTE: Both Ethernet ports operate at 100 Mbps Full Duplex. They will not operate at 10 Mbps or at half duplex.

Action

Log in

Set BH-side Ethernet auto- negotiation

Set LAN-side Ethernet auto-negotiation

Log off

Steps

Press Enter.

At the username prompt, enter admin.

At the password prompt, enter password.

Enter set canopy port auto negotiation [on/off]

where

on enables auto negotiation at 100 Mbps Full Duplex (as default). off forces the port to 100 Mbps Full Duplex without auto negotiation.

RESULT: The system responds

Canopy port auto-negotiation is: on

Enter set lan port auto negotiation [on/off]

where

on enables auto negotiation at 100 Mbps Full Duplex (as default). off forces the port to 100 Mbps Full Duplex without auto negotiation.

RESULT: The system responds

LAN port auto-negotiation is: on

Enter lo.

RESULT: The system responds goodbye.

end of procedure

Issue 3

Page 39 of 73

Page 39
Image 39
Motorola T1/E1 manual Configure Ports, Procedure 10 Configuring the Ethernet ports using the CLI, Action