Motorola T1/E1 manual Enter set clock source loopback/recovered

Canopy T1/E1 Multiplexer					September 2004
			T1/E1 Multiplexer FPGA Version 3.4
	Action			Steps
Set timing mode		NOTE: Timing mode applies to all four T1 lines. Loopback mode loops the
		T1/E1 Tx clock to the T1/E1 Rx. Recovered mode recovers the T1/E1 clock
		from the incoming T1/E1 over Ethernet bit stream (recovers the clock from
		the far end T1/E1). The default timing mode is Recovered.
		Enter set clock source [loopback/recovered]
		where
		[loopback/recovered] represents the clock timing mode.
		RESULT: The system responds
		Clock source is [loopback/recovered]
Set master clock		NOTE: This is the master clock reference for all four T1/E1 lines.
reference line		The default setting is T1/E1 Port 1.
		Enter set master clock reference line [1/2/3/4]
		where
		[1/2/3/4] represents T1/E1 ports 1 through 4.
		RESULT: The system responds
		Clk ref line; [1,2,3,4]
Set backup clock		NOTE: This is the optional backup clock reference for all four T1/E1 lines.
reference line		The backup clock reference becomes active only when the master clock
		reference line is unavailable. The default setting is T1/E1 Port 2.
		Enter set secondary clock reference line [1/2/3/4]
		where
		[1/2/3/4] represents T1/E1 ports 1 through 4.
		RESULT: The system responds
		Backup clk ref line; [1/2/3/4]
Log off		Enter lo.
		RESULT: The system responds goodbye.
			end of procedure

Issue 3 Page 41 of 73