Canopy T1/E1 Multiplexer | September 2004 |
| T1/E1 Multiplexer FPGA Version 3.4 |
Figure 28: Invalid key entry window
NOTE: At any later date, you can confirm the number of enabled ports as follows.
4.From the main menu, select Config→Canopy T1/E1 Mux.
RESULT: The Canopy T1/E1 Mux Configuration window opens, as shown in Figure 29.
Figure 29: Canopy T1/E1 Mux Configuration window
5.In the lower right quadrant of the window, find the Enabled T1/E1 Ports block. NOTE: Each enabled port is identified by a black check mark.
end of procedure 
Issue 3 | Page 62 of 73 |
