Canopy T1/E1 Multiplexer | September 2004 |
| T1/E1 Multiplexer FPGA Version 3.4 |
3.3SYSTEM RESET
Follow the steps below to reset the system from the CLI.
Procedure 25: Resetting the system using the CLI
Action
Log in
Reset system
Steps
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
Enter reset.
RESULT: The system responds Resetting, then immediately resets both Ethernet Interfaces and all 4 T1/E1 interfaces without asking for a confirmation.
end of procedure 
Follow these steps to reset the system using the EMS.
Procedure 26: Resetting the system using the EMS
1.Select the File→Reset menu option. RESULT: A confirmation window pops up.
2.To reset the system, select Yes.
NOTE: Selecting No cancels the action, and the system will not be reset.
Figure 22: EMS reset confirmation box
end of procedure 
Issue 3 | Page 56 of 73 |
