Canopy T1/E1 Multiplexer | September 2004 |
| T1/E1 Multiplexer FPGA Version 3.4 |
WARNING!
Substitution of the power supply may impair intrinsic safety. The Canopy T1/E1 Multiplexer must be used with Model Number TR10R033 manufactured by Cincon Electronics Co., Ltd.
2.2INSTALLATION PROCEDURES
2.2.1Package Contents
Verify the contents shipped against the packing list for the box. You should have received the following:
◦T1/E1 unit
◦AC Power supply (Option 1 only)
◦CD ROM (EMS GUI and the software download application)
2.2.2Preparing for Installation and Setup
Select the appropriate type of cable for connection to the Ethernet port of the Canopy T1/E1 Multiplexer as follows:
◦For connection to a LAN or a switch, a
◦For connection to the NIC card in a PC, a crossover cable is required.
◦For connection to a PBX, a T1/E1 crossover cable is likely required. Refer to your PBX installation instruction manual for specific requirements.
2.2.3Mounting the Canopy T1/E1 Multiplexer
Mounting option for the unit is either a desk mount or a rack mount. Follow this procedure to affix the until to a rack mount:
Procedure 1: Affixing the Multiplexer to a rack mount
Remove the Front Panel by removing Front Panel Mounting Screws.
1.Remove the two screw posts from the
2.Remove Front Bezel and set aside.
Issue 3 | Page 28 of 73 |
