Motorola T1/E1 manual Configuration Procedures Using the EMS, End of procedure

Canopy T1/E1 Multiplexer			September 2004
		T1/E1 Multiplexer FPGA Version 3.4
Action		Steps
Set timing mode	NOTE: Timing mode applies to all four E1 lines. Loopback mode loops the T1/E1
	Tx clock to the T1/E1 Rx. Recovered mode recovers the T1/E1 clock from the
	incoming T1/E1 over Ethernet bit stream (recovers the clock from the far end
	T1/E1). The default timing mode is Recovered.
	For master clock timing mode, enter
	set clock source loopback
	RESULT: The system responds
	Clock source is loopback
	For slave clock timing mode, enter
	set clock source recovered
	RESULT: The system responds
	Clock source is recovered
Log off	Enter lo.
	RESULT: The system responds goodbye.
		end of procedure

2.5CONFIGURATION PROCEDURES USING THE EMS

2.5.1Logging into the System

Procedure 14: Logging in using the EMS

If you are using the EMS to access the system, follow the steps below to log in:

1.Select the proper COM Port for your PC. NOTE: COM1 through COM4 are supported.

2.Enter the User Name.

NOTE: The default username is admin. This value cannot be changed.

3.Enter the Password.

NOTE: The default password is 123. If the password has been changed, enter the correct password.

4.Select the Login button to continue with the login.

NOTE: If the login is unsuccessful, the system will generate a pop-up error window. You may return to the Login window to correct the data.

Issue 3 Page 45 of 73