Motorola T1/E1 manual Select Line Coding, Procedure 9 Configuring line coding using the CLI

Canopy T1/E1 Multiplexer	September 2004
	T1/E1 Multiplexer FPGA Version 3.4

2.4.4Select Line Coding

Procedure 9: Configuring line coding using the CLI

Follow this procedure to select the appropriate line code using the CLI manager.

	Action		Steps
Log in		Press Enter.
		At the username prompt, enter admin.
		At the password prompt, enter password.
Set line code		Enter set line [1/2/3/4] code [HDB3/B8ZS/AMI]
		where
		HDB3 sets the line type to HDB3 for all 4 E1 ports
		B8ZS sets the line type to B8ZS for all 4 T1 ports.
		AMI sets the line type to AMI for all 4 E1 or T1 ports.
		RESULT: The system selects the line code for all four ports, as in the
		following example.
		Line code [1/2/3/4] set to [HDB3/B8ZS/AMI]
Get line code		Enter get line code.
		RESULT: The system returns the line code for all four ports, as in the
		following example.
		Line code [1/2/3/4] set to [HDB3/B8ZS/AMI]
			end of procedure

Issue 3 Page 38 of 73