Canopy T1/E1 Multiplexer

September 2004

 

T1/E1 Multiplexer FPGA Version 3.4

Figure 1: Canopy T1/E1 Multiplexer with Canopy BHs

The T1/E1 Multiplexer converts the data stream from T1/E1 ports into Ethernet packets that are then transported over the Canopy BH link. This device can be used to extend T1/E1 services. You can configure the Canopy T1/E1 Multiplexer to operate as either a T1 or an E1 device.

Applications of the T1/E1 Multiplexer include

obviating leased lines.

implementing wireless PBX networking.

establishing cellular backhaul links.

providing homeland security backup or emergency voice networks.

routing LAN/WAN data on excess bandwidth.

1.2.1Ethernet Interface

The Ethernet physical layer auto-negotiation should be set to on for both sides of the Canopy T1/E1 Multiplexer.

RJ-45 connector pin-outs for the Ethernet cable from the BH to the Canopy port of the Canopy T1/E1 Multiplexer are illustrated in Figure 12 on Page 30.

Issue 3

Page 10 of 73

Page 10
Image 10
Motorola manual Ethernet Interface, Canopy T1/E1 Multiplexer with Canopy BHs