Canopy T1/E1 Multiplexer

September 2004

 

 

T1/E1 Multiplexer FPGA Version 3.4

 

 

 

 

 

 

Figure 11: Front panel and front bezel removed

3.Place the Canopy T1/E1 Multiplexer behind the desired Rack Panel mounting hole.

NOTE: The Rack Panel will support three (3) Canopy T1/E1 Multiplexers.

4.Place the Front Panel on the front of the Rack Panel opening, positioning the Rack Panel Spacer between the two panels.

5.Insert the front panel mounting screws through the screw holes.

6.Tighten screws.

7.Insert the screw posts onto the DB-9 connector.

8.Tighten screw posts.

9.Mount the Canopy T1/E1 Multiplexer with the rack panel onto your rack unit. Consult the product information supplied by the rack manufacturer for details. NOTE: The front panel mounting screws should be 4-40 screws, between 3/8” and 5/8” long.

end of procedure

2.2.4Connecting the Canopy T1/E1 Multiplexer

Table 12: T1/E1 port connector pin-out

Pin

Designation

Direction

 

 

 

1

RD(R)

Input

 

 

 

2

RD(T)

Input

 

 

 

3

FGND

 

 

 

 

4

TD(R)

Output

 

 

 

5

TD(T)

Output

 

 

 

6

FGND

 

 

 

 

7, 8

FGND

Not connected

 

 

 

Function

Receive data (ring) Receive data (tip)

Transmit data (ring) Transmit data (tip)

Issue 3

Page 29 of 73

Page 29
Image 29
Motorola manual Connecting the Canopy T1/E1 Multiplexer, End of procedure, T1/E1 port connector pin-out, Function