Canopy T1/E1 Multiplexer

September 2004

 

T1/E1 Multiplexer FPGA Version 3.4

10.At the username prompt, enter admin.

11.At the password prompt, enter your new password.

end of procedure

2.4.3Select Line Type T1 or E1

Procedure 8: Selecting line type T1 or E1 using the CLI

Follow this procedure to select the appropriate line type using the CLI manager.

Action

Steps

Log in

Press Enter.

 

At the username prompt, enter admin.

 

At the password prompt, enter password.

 

 

Get line type

Enter get line type.

 

RESULT: The system returns the line type for all four

 

ports, as in the following example:

 

Line type [T1/E1]

Set line type

Enter set line type [T1/E1]

 

where

 

T1 sets the line type to T1 for all 4 ports.

 

E1 sets the line type to E1 for all 4 ports.

 

RESULT: The system acknowledges the new setting for

 

line type for all four ports, as in the following example:

 

Line type [T1/E1]

 

 

Reset system

Enter reset.

 

RESULT: The system responds Resetting, then

 

immediately resets both Ethernet Interfaces and all 4

 

T1/E1 interfaces without asking for a confirmation.

CAUTION!

The previously configured line type remains in effect until the system is reset. Therefore, this step should always be followed by a reset.

end of procedure

Issue 3

Page 37 of 73

Page 37
Image 37
Motorola T1/E1 manual Select Line Type T1 or E1, Procedure 8 Selecting line type T1 or E1 using the CLI, Action Steps