Motorola T1/E1 manual Initial Configuration Procedures, Installing Software from the CD‐ROM

Canopy T1/E1 Multiplexer	September 2004
	T1/E1 Multiplexer FPGA Version 3.4

Figure 13: Rear panel Option 2: −48 v DC polarity

3. Connect the power cables to an external −48 v DC supply.

end of procedure

2.3INITIAL CONFIGURATION PROCEDURES

2.3.1Installing Software from the CD‐ROM

Procedure 5: Installing Software from the CD-ROM

Follow these steps to install the software that is provided by Motorola Canopy on the CD- ROM onto your PC.

1.Load software onto your PC.

The T1/E1 Multiplexer EMS Graphical User Interface is provided by Canopy on a CD-ROM that is shipped with the unit.

2.Install the software from the CD-ROM by double-clicking the setup application or

3.Issue the Start->Run->d:/setup sequence

where d: is the drive letter of your CD-ROM. If you are using a different drive letter, simply substitute the appropriate drive letter.

end of procedure

Issue 3 Page 32 of 73