Canopy T1/E1 Multiplexer | September 2004 |
T1/E1 Multiplexer FPGA Version 3.4
Figure 5: Rear panel with optional −48 v power supply adapter for battery backup
The recommended sequence of connection is:
1.Connect a PBX or TDM CPE to the T1/E1 port(s). (See Figure 2 on Page 11.)
2.Connect the Ethernet cable from the Canopy Backhaul Module to the jack labeled Canopy. (See Figure 2 on Page 11.)
3.Connect the selected power adapter to the T1/E1 Multiplexer. (See Figure 3 and Figure 4.)
4.Power the T1/E1 Multiplexer on. (See Figure 3.)
5.As required to configure the T1/E1 Multiplexer, connect a notebook computer to the jack labeled CONTROL on the front panel of the T1/E1 Multiplexer. (See Figure 6.)
Issue 3 | Page 13 of 73 |
