Motorola T1/E1 manual Enter get clock source, Enter get master clock reference line

Canopy T1/E1 Multiplexer		September 2004
	T1/E1 Multiplexer FPGA Version 3.4
Desired Action	Syntax, Response, and Description
Get the timing mode	Enter get clock source
	The system responds
	Clock source set to [loopback/recovered]
	Gets the T1 timing mode. This timing mode applies for all four T1 lines.
	Loopback mode means to take the T1 Tx clock and loop it back to the
	T1 Rx. Recovered mode means to recover the T1 clock from the
	incoming T1 over Ethernet bit stream, in other words to recover the
	clock from the far end T1.
Get the master	Enter get master clock reference line
clock reference line
	The system responds Clk ref line: [1/2/3/4]
	NOTE: [1/2/3/4] represents T1/E1 ports 1 through 4.
	Displays the T1 master clock reference line. This clock reference
	applies for all four T1 lines.
Get the secondary	Enter get secondary clock reference line
clock reference line
	The system responds Backup clk ref line; [1/2/3/4]
	NOTE: [1/2/3/4] represents T1/E1 ports 1 through 4.
	Displays the T1/E1 secondary or backup clock reference line. This
	clock reference is the backup clock reference for all four T1/E1 lines.
	The backup clock reference will become active only when the master
	clock reference line is unavailable.

Issue 3 Page 69 of 73