Canopy T1/E1 Multiplexer

September 2004

 

T1/E1 Multiplexer FPGA Version 3.4

Procedure 11: Configuring the T1 ports using the CLI

Follow this procedure to configure the T1 ports from the CLI manager.

Action

Steps

 

 

Log in

Press Enter.

 

At the username prompt, enter admin.

 

At the password prompt, enter password.

 

 

Set T1 line length

NOTE: If the incorrect line length is selected, the result could be decreased

 

T1 quality or echo on voice lines. The default length is 133 ft.

 

Enter set line [1/2/3/4] length [133, 266, 399, 533]

 

where

 

[1/2/3/4] represents T1 ports 1 through 4.

 

[133, 266, 399, 533, 655] represents line length in feet.

 

RESULT: The system responds

 

Line [1/2/3/4] length [0-133 / 0.6 dB; 133-266 / 1.2

 

dB; 266-399 / 1.8 dB; 399-533 / 2.4 dB; 533-655 / 3.0

 

dB]

 

 

Set T1 line code

NOTE: If the line code does not match the incoming T1 settings, then Bipolar

 

Violations (BPVs) will occur. The default code is B8ZS.

 

Enter set line [1/2/3/4] code [B8ZS/AMI]

 

where

 

[1/2/3/4] represents T1 ports 1 through 4.

 

[B8ZS/AMI] represents the line coding scheme.

 

RESULT: The system responds

 

Line [1/2/3/4] code [B8ZS/AMI]

 

 

Issue 3

Page 40 of 73

Page 40
Image 40
Motorola T1/E1 manual Procedure 11 Configuring the T1 ports using the CLI, DB 266-399 / 1.8 dB 399-533 / 2.4 dB 533-655