Motorola T1/E1 manual List of Figures

		3.4.2 Invoking a T1/E1 Loopback Using the EMS	58
	3.5	Measurements from Diagnostics	59
	3.6	Firmware Upgrades	59
	3.7	License Key Upgrades	61
	3.8	Terms of Warranty	63
		3.8.1 Software License Terms and Conditions	63
		3.8.2 Hardware Warranty in U.S	65
	3.9	Obtaining Technical Support	65
	3.10	Invoking Your Warranty Rights	66
4	Canopy T1/E1 Multiplexer Reference Information		67
	4.1	CLI Commands to Get Status Information	67
	4.2	Regulatory Compliance Information	71
		4.2.1 Federal Communication Commission Declaration of Conformity Statement	71
		4.2.2 Department of Communications – Canada	72
		4.2.3 European Telecommunications Standards Institute	72
	4.3	Trademarks, Product Names, and Service Names	72
	4.4	References	73

LIST OF FIGURES
Figure 1: Canopy T1/E1 Multiplexer with Canopy BHs	10
Figure 2: Canopy T1/E1 Multiplexer rear panel	11
Figure 3: Rear panel with standard 110-v source power supply	12
Figure 4: Standard adapters for global use	12
Figure 5: Rear panel with optional −48 v power supply adapter for battery backup	13
Figure 6: Canopy T1/E1 Multiplexer front panel	14
Figure 7: Master and secondary clock settings (top view)	22
Figure 8: Master timing set to Loopback mode	23
Figure 9: Slave timing set to Recovered mode	24
Figure 10: Network timing scenarios	24
Figure 11: Front panel and front bezel removed	29
Figure 12: RJ-45 Ethernet connection pin-outs (LAN side)	30
Figure 13: Rear panel Option 2: −48 v DC polarity	32