warning! Verify that the vehicle is set to park and that the parking brake is set before beginning installation.
step 1
Ground Wire
The BLACK wire on the main 8-pin harness is ground. This wire should be connected to a clean, paint-free area of metal in the drivers kick panel area. First strip back a ¾-inch section of the insulation off the BLACK wire and crimp a ring terminal (not provided) to that wire. Locate a clean, paint-free metal surface in the drivers kick panel. Using a self-tapping screw, drill the screw with the ring terminal to the metal area. Once screwed down, pull on the wire to ensure a good connection.
note: More problems are attributed to poor ground con- nections than any other cause. Take extra care to ensure the ground is clean and secure.
SELF-TAPPING
BOLT OR SCREW
GROUND
WIRE
| NOTE: REMOVE ANY PAINT | RING |
DIA-591 | BELOW RING CONNECTOR | CONNECTOR |
10 | | © 2002 directed electronics, inc . |
