step 10
Testing the system
Once steps 1-9 have been completed, the operation of the system can be tested.
Place the two 30-amp fuses back into the relay satellite RED wire fuse holders. Make sure that the vehicle is in park with the
emergency brake on and the hood closed. Press 
and 
on the remote control simultaneously to initiate the remote start function. The parking lights should flash to confirm the remote start command has been received, The accessories and ignition should turn on followed by the starter cranking and the vehicle
engine running. Pressing 
and 
again simultaneously will shut the engine off.
transmitter functions
The receiver uses a computer-based learn routine to learn the transmitter buttons. This makes it possible to assign any specific transmitter button, or combination of buttons, to any receiver function. The transmitter initially comes programmed in the Standard Configuration, but may also be customized by an authorized dealer. Unless otherwise specified, the buttons used in all of the instructions in this manual correspond to a Standard Configured transmitter.
© 2002 directed electronics, inc . | 27 |
