➤The vehicle starts, but the starter keeps running.
Is the system programmed for engine checking off or voltage sense? When programmed for either of these features, the engine cranks for the preprogrammed crank time regardless of how long it takes to start the vehicle to actually start. Adjust to a lower cranking time.
Was the Tach Learn successful? The LED must light solidly and brightly to indicate a successful learn.
Make sure that there is a tach signal right at the purple/white tach input wire of the remote start. If not, recheck the connection to the vehicle’s tach wire and make sure the wire is not broken or shorted to ground leading to the remote start.
➤The vehicle will start and run only for about 10 seconds. Is the remote start programmed for voltage sense? Try programming the unit for low voltage reference. If this does not work, a tach wire should be used.
40 | © 2002 directed electronics, inc . |
