Remote Gain Operation
NOTE: Do not use the Remote Gain control when you have an expanded system installed (see Line Ouput Configurations). The Slave amplifier(s) gain will not be controlled.
The remote gain port provides easy remote access to the internal gain structure of the HCCA power amplifier. The
AMPLIFIER WIRING
Power Connections for the
●Orion
●Orion
●Power connections accept up to 4 AWG wire.
●4 AWG power and ground wire recommended for optimal performance.
●Connect 12V+ to the battery through fuse holder. This connection provides +12V main power to the amplifier.
●Power wire must be fused no more than 18" from battery.
●Ground amplifier to a good chassis ground as close as possible to the amplifier.
●Connect REM terminal to remote
●Add extra ground wire between the negative terminal of the battery and the chassis.
Power Connections for the HCCA-D5000
●Orion
●Power connections accept up to 4 AWG wire.
●Dual 4 AWG power and ground wire required for proper performance.
●Connect 12V+ to the battery through power distribution and fuse holder. This connection provides +12V main power to the amplifier.
●Power wires must be fused no more than 18" from battery.
●Terminate both grounds of the amplifier to a good chassis ground as close as pos- sible to the amplifier.
●Connect REM terminal to remote
●Add an extra ground wire between the negative terminal of the battery and the chassis. Either dual 4 AWG or single 1/0 AWG is recommended.
NOTE: The addition of a ground wire from the battery to the chassis of the vehicle improves the ability of the battery to supply power to the amplifier. This is recom- mended because the current delivery of the factory electrical system was designed only to accommodate electronics supplied by the auto manufacturer.
WARNING! The Orion
© 2006 Directed Electronics, all rights reserved | 11 |
