SIRIUSDesktopEcho SignalDockingRepeaterStationSystem
Using the SIRIUS Echo Signal Repeater System
When the Echo Transmitter and Echo Antenna have been installed, turn on the SIRIUS radio and check the Antenna Aiming/Signal Strength display to verify the SIRIUS signal strength. If the SIRIUS signal strength is good, and the audio from the SIRIUS radio is good, the system is working properly. If the SIRIUS signal strength is not good, or the audio from your SIRIUS radio is either absent or intermittent, then the system installation needs to be fine tuned. Please consult the troubleshooting section in this manual.
SIRIUS Echo Signal Repeater System and SIRIUS Conductor System - Coexistence
The SIRIUS Echo Signal Repeater System has been designed to minimize interference between any of its own system components (Echo Transmitter and Echo Antenna) and other wireless devices that are typically found in a home such as certain cordless phones, baby monitors, wireless headphones etc. However, to get the best performance out of your SIRIUS Echo system and these other devices, we advise that you
avoid placing the Echo Transmitter and the Echo An- tenna close to these other products.
Special consideration in product placement should be given if you want to operate both the SIRIUS Echo Signal Repeater System and the SIRIUS Conductor System in your home. In this case, we recommend that you place the Echo Transmitter and the SIRIUS Conductor Tuner as far apart from each other as possible and at least in separate rooms. This type of placement would maximize the chances of getting the best performance out of both systems. Also, if the SIRIUS Conductor Remote is used in close proximity of the Echo Transmitter, you may experience some reduction in its range. Also, if the SIRIUS Conductor Remote is used in close proximity to the Echo Trans- mitter, you may experience some reduction in the Conductor Remote's range.
© Directed Electronics, all rights reserved.
17
