DIRECTV Set-top box information for the installer
DIRECTV Proprietary November 17, 2005
Version 1.1.a Page 23 of 49 DTV-MD-0058
0xD1 CH + (key #19) 0xE9 Digit 9 (key #18)
0xD2 CH – (key #20) 0xEA Red (key #39)
0xD3 Guide (key #25) 0xEB Yellow (key #40)
0xD4 Exit (key #30) 0xEC Green (key #41)
0xD5 Power (key #7) 0xED Blue (key #42)
0xD6 Previous Channel (key #21) 0xF7 Menu (key #28)
Note: All keys not otherwise identified above will be considered RESERVED.
Return Response ACK_FCNOK : Success
NACK_FCNOK : Failure – No User Command available since last request
Return Value 0x0000 : Success
Non-Zero : Failure – No User Command available since last request
Description The STB will execute a GetUserCommand command by providing the remote control
or front panel key presses via the Return Data Stream.
The DisableUserEntry command will be called prior to calling the GetUserCommand
command.
If a user command has transpired since the last GetUserCommand request, the user
command Type, Device, and Contents are placed in the return data stream. If a user
command has not been made since the last request, the NACK_FCNOK is returned
instead.
The GetUserCommand is used to identify the type, device and key. For example, if
the user pressed and released the Select (0xC3) key then one GetUserCommand is
required. The GetUserCommand provides a Type of 0x00 (Key Toggle), Device of
0x01 (Remote) and Key of 0xC3 (Select key). On the other hand, if the user pressed
the Select (0xC3) key, held it so that the remote repeats the command, and then
released it on the remote control, two (2) GetUserCommands are required. The first
GetUserCommand provides a Type of 0x01 (Key Down), Device of 0x01 (Remote)
and Key of 0xC3 (Select key). The second GetUserCommand provides a Type of 0x03
(Key Up), Device of 0x01 (Remote) and Key of 0xC3 (Select).
5.9 EnableUserEntry (0x93)
Command Label EnableUserEntry
Command Byte 0x93
Input Parameter(s) None
Return Data Stream None
Return Response ACK_FCNOK : Always Success
Return Value 0x0000 : Always Success
Description The STB executes an EnableUserEntry command by allowing remote control and
front panel key presses to reach the user interface handler.