DirecTV pmn manual Searching for Your Code in AV1 or AV2 Mode, Verifying the Codes

SEARCHING FOR YOUR CODE IN AV1 OR AV2 MODE

If you were unable to find the code for your brand of TV or component, then you can try a code search. This process may take up to 30 minutes.

1.Turn on the TV or component.

2.Move the slide switch to the AV1, AV2 or TV position.

3.Press and hold the MUTE and SELECT keys at the same time until the green light under the selected switch posi- tion flashes twice and then release both keys.

4.Enter in 9-9-1followed by one of the following 4-digits:

COMPONENT TYPE	COMPONENT ID #
Satellite	0
TV	1
VCR/DVD/PVR	2
STEREO	3

6.Point the remote at the TV or component and press CHAN S. Repeatedly press the CHAN Suntil the TV or component turns off.

Note: Every time CHAN Sis pressed the remote advances to the next code and power is transmitted to the component

7.When the TV or component turns off, stop pressing the CHAN Skey. Then, press and release the SELECT key.

NOTE: If the light flashes 3 times before the TV or component responds, then you've cycled through all codes and unfortunately the code you need is not available. You must use the remote that came with your TV or component.

VERIFYING THE CODES

If you have setup the DIRECTV Universal Remote Control using the SEARCHING FOR YOUR CODE PROCEDURE, you can find out the 5-digit code your component responded to with the following instructions:

1.Move the slide switch to appropriate position.

2.Press and hold the MUTE and SELECT keys at the same time until the green light under the selected switch flashes twice and then release both keys.

3.Enter in 9-9-0(The green light under the selected switch position will flash twice)

4.To view the first digit in the code, Press and release the number 1 key. Wait three seconds, and count the num- ber of times the green light flashes. Write this number down in the leftmost TV, AV1 or AV2 code box found on pages 11 or 12.

Note: If this part of the code is "0" the light will not flash

23