3. Press the up or down arrow to change the track in view. To select a track to
copy to the blank disc press the ENT key, a + will appear next to the track in
view. In the following example track 3 is in view and is selected for copying.
More than one track can be chosen from a CD but they will be recorded to
the destination in the order in which they are on the original CD. To change
the order of play copy each track individually.
4.After selecting a track (or tracks) to copy press the up arrow until “End”
appears. In this example one track is selected and the time for this track is
2:41.
If four tracks were selected the screen would show “4 Trk” and give the total
time for all four tracks.
5. Load the other recorders, one or as many as needed, with high quality CD-R
media.
6. Press the ENT button and the ReflexPro DVDwill ask if all the selections are
made for this CD. Use the up or down arrow to change between Yes and No.
Pressing ENT with No on the LCD will take the user back to Select Track.
Pressing ENT with Yes on the screen will start the copying of the track (or
tracks) to the target CD.
7.When the copying ends the unit will display “Burn Complete! OK: 01”. Press
the ENT button. The LCD will display “Continue edit next Disc? NO”. To change
to another CD, Load the top recorder drive (Src) with another master disc,
press the up arrow to change the “No” to “Yes”and press ENT. This will take
you to the screen from step 3. Repeat steps 3 through 6 to add more tracks
on the compilation.
8.When there are no more tracks to write to the compilation leave the
“Continue edit next Disc? NO” set to “No” and press the ENT key again. The
following screen will appear:
Press ENT and the ReflexPro DVD will close the CD.
The LCD will display “Close Complete OK: ... Fail: ...” the number of discs
closed successfully will be next to OK and they will be ejected, any failures
will remain in the recorder drives.
The ReflexPro DVD can compile to the hard drive as well, in step 2 use the
down arrow to to select “10-02. Edit Track DVD to hard drive Edit” and press
enter. Steps 3 and 4 will be the same to select the tracks to copy. It is not
necessary to load any media. Step 6 will load the selected track(s) to the
hard drive. The last few steps will be as follows:
7.When the copying ends the unit will display “Image load OK”, pressing ‘ENT
will display “Continue edit next Disc? NO” Leaving this set to “No” and press-
ing ‘ENT’ the screen will display “Burn or Move to partition? Burn”. Use the
down arrow to change the “Burn” to “Move” then press ‘ENT’. “Select Partition
A” will be displayed. Use the down arrow to select a partition to copy to and
1-800-237-6666 www.discmakers.com T
11
Select Track:
+3/31 3:18
TRACKIN VIEW
TOTALTRACKS ON DISC
TIMEOF TRACK 1
Select Track:
End 1 Trk 2:41
End edit disc
and burn? YES
Close all discs
session? YES