PROGRAMMING THE REMOTE TO CONTROL A SECOND RECEIVER IN AUX MODE
If you have another DISH Network satellite receiver installed, you can use this remote in AUX mode to control it along with your new receiver. When you program the remote to control the other receiver, the remote will send out IR and UHF (not UHF Pro) signals to the receiver. You can program the remote to control any other DISH Network satellite receiver, except for following:
•TV2 on DISH 322, DISH
•DishPlayer 7100/7200
1.Turn on the other receiver and display the System Info screen (see the receiver user’s guide for information on how to display the screen).
Write down the address shown:
2.Press and hold the AUX button until all the other mode buttons light up, and then let go of the button. The AUX button flashes.
3.Press the 3 button.
4.Use the NUMBER PAD to enter the address you wrote in step 1.
5.Press POUND (#). The AUX button blinks three times.
6.Press RECORD to make sure the address and the remote matches the address on the receiver.
READING OUT THE REMOTE CONTROL CODES
These instructions explain how to check the remote control code you put in the remote control when you set it up. Be sure to write them in the spaces provided below.
Instructions | Additional Information |
1Press and hold the mode button for the equipment you want the remote to con- trol. When all the other mode buttons light up, let go of the mode button - that mode button should now be flashing.
For example, hold the TV mode button for a TV until all of the other mode buttons light. When you let go, the TV mode light will flash.
7
