6.Move the highlight to the address for the 
Remote Address as shown below. This is important - if you do not move the
highlight, your remote will change the receiver's 
Remote Address and cause your Remote Control 1 to control the TV2 side of your receiver.
i1
UHF
Remote Addrs. | 5 |
TV Out | 3 |
Note: Highlight the 
Remote Address (the shaded area in the graphic above).
7.Press the RECORD button on the green TV1 remote control you are setting up. If you get a warning that tells you to pick another address, continue on to the next step. If no warning pops up, go to the step 12 of this procedure.
8.On the remote control, press and hold the SAT mode button about three seconds, until all the mode buttons light up, and then let go of the SAT button. The SAT mode button will blink.
9.Use the number buttons to enter any number from 1 to 16, except for the address shown for 
.
Write down the number you entered:
10.Press the POUND (#) button. If you entered the address correctly, the SAT mode button will flash three times.
11.Make sure the System Information screen shows 
UHF and that this address matches the number you entered in step 9.
12.Select Done to close the System Information screen. If nothing happens, press RECORD, and then select Done.
11
