Remote Control Setup

Improving Receiver Control

1Press and hold the SAT mode button for three seconds, until all of the mode buttons light up, and then let go of the SAT button.

2Press POUND (#) twice. The SAT mode button will flash the same number of times as the address number (for example, three flashes means address 3).

Confirming Remote Control Operation

 

Model ID

ViP612 CVR-SD

Receiver CAID

R0079256789-30

 

Smart Card ID

S1907972574-12

Software Version

DNASP206 Dsh689

AEE2WAND-N

Boot Strap Version

1010WAND

 

Billing & Programming

1-800-333-DISH(3474)

Technical Assistance

1-800-333-DISH(3474)

Internet Address

dishnetwork.com

Receiver Mode

Single Mode

 

 

Location ID

87940875:00000004

Remote Address

IR/UHF Pro Band A

Help

Done

Cancel

1Make sure the remote has fresh batteries and is in SAT mode.

2Press SYSTEM INFO on the receiver front panel to display the system information screen.

3Press RECORD on the remote control:

The Remote Address in the system information screen changes to match the address preset in your remote control.

4Press POWER on the remote control to turn on/off receiver.

Changing the Remote Control from UHF Pro to IR

Your receiver accepts both UHF and IR (Infrared) commands. The remote control only outputs UHF Pro signals but can be changed to transmit IR commands by switching the key at the bottom. This is also useful for programming an after-market universal learning remote control to operate your receiver. Note that when the remote control is in IR mode, you will need to use it from the same room to operate the receiver because IR signals do not travel through walls or over great distances.

63

Page 3
Image 3
Dish Network VIP612 manual Confirming Remote Control Operation, Changing the Remote Control from UHF Pro to IR