INSTALLATION
Unravel the AC cord and connect it to a
conveniently located AC outlet having 120V and 60Hz only. The Clock Display will illuminate and “12:00” will blink in the display and the backlight will light.
NOTE: If the AC plug does not fit into a nonpolarized outlet, do not file or cut the
wide blade. It is the user’s responsibility to have an electrician replace the obsolete outlet.
If the AC cord is disconnected or if there is a power failure, this electronic clock is designed to continue operating internally (without showing the time on the Clock Display) with two (2) AAA size batteries (not included).
To install the batteries: |
|
|
|
| |
• | Remove the battery compartment door by inserting a |
|
|
|
|
| small screwdriver, paper clip or similar item into the tab |
|
|
|
|
| while gently pushing to remove. | + |
| – |
|
|
|
|
|
| |
• | Insert two (2) AAA size batteries into the battery | – |
| + |
|
| compartment. Be sure to observe the polarity markings |
|
| ||
|
|
|
|
| |
|
|
|
|
| |
| which are engraved inside the battery compartment. If the |
|
|
|
|
|
|
|
|
| |
| batteries are inserted incorrectly, the unit will not operate. |
|
|
|
|
• Replace the battery compartment door. |
|
|
|
| |
Be sure to check the condition of the batteries periodically by disconnecting the AC cord and connecting it again two or three minutes later. The preset times should continue operating. If the present time does not appear, it indicates the batteries are dead or not connected properly.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1.Use only the size and type of batteries specified.
2.Be sure to follow the correct polarity when installing the batteries as indicated next to the battery compartment. Reversed batteries may cause damage to the device.
3.Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and
4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)
7
