ELECTRICAL SYSTEMS
Keep all connections clean and tight. Maintain the fluid in the battery at correct level.
BODY
The body may be washed with a mild detergent and waxed with any automotive type wax.
TRANSAXLE
For adjustment or repair confer with authorized Dixon dealer service department. Adjustment or repair by other than authorized dealer voids warranty.
SPARE PARTS
See your dealer for ordering spare parts or warranty service.
INSTALLING AND REMOVING MOWER DECK FROM FRAME
1.Attach stabilizer arms to mower deck with pins and
2.Attach the ½ “ dia. engaging rod with a rollpin through the engaging cam.
3.Position the drive belt on pulleys.
4.Place mower deck under unit in approximate operating position with engaging rod through hole in the floor.
5.Connect drive belt to lower engine pulley, being certain that belt is inside of belt guides. Loosen belt keeper by loosening the two rear engine mount bolts; this will allow belt to be placed on motor pulley. Retighten engine mount bolts.
6.Attach lift linkage to mower deck on the inside of the attaching lugs as shown on drawing with pins and clips. (4 places)
7.Attach stabilizer arms to pivot point on the inside of attaching bracket with pins and clips.
8.Place engaging handle on engaging rod and fasten with bolt and locknut.
9.Connect pan wire loom plug to plug on frame wire loom. Mower will not start unless this connection is made.
10. After installing pin clips, rotate pins so that open end of clip is down.
