Dixon 46, 965882301, 965882101, 965981001, 965882201, 54 manual Adjusting the Mower Deck, Deck Leveling

MAINTENANCE

Adjusting the Mower Deck

Deck Leveling

Adjust the deck while the mower is on a level surface. Make sure the tires are inflated to the correct pressure. See “Technical Data” under Transmission. If tires are under or over inflated, the deck cannot be properly adjusted.

The deck should be adjusted slightly higher in the rear.

NOTE: To insure accuracy of leveling procedure, mower deck drive belt must be installed prior to leveling deck.

1.Wear heavy gloves. Turn each outer blade tip to align with the deck or in a side-to-side manner.

2.Measure from the floor surface up to the bottom of the blade tip on the discharge side of the mower deck. Retain this measurement.

3.Move to the opposite side, check that measurement is the same. If adjustment is required—with a ¾" or adjustable wrench, turn the lift link adjustment nuts on either side counter clockwise to lower or clockwise to raise. Adjust until both side-to-side measurements are equal.

8058-030

Lift link adjustment nut

4. Turn any blade to align with the deck in front- to-rear manner. If the rear blade tip does not measure 1/8" to ½" higher, follow the front adjustment instructions that follow.

5. With a 5/8 or adjustable wrench, turn the nuts on the front suspension linkage. Clockwise raises the front of the mower, counter clockwise will lower the front. Adjust nuts until rear of mower deck is positioned level to 1/8" higher in the rear than the side-to-side measurement.

NOTE: This will place the mower deck in a base measurement position. Additional adjustment may be required to achieve desired cut for the type of grass or conditions being mowed.

8058-031

Deck front adjustment nuts

48-DIXON