Dixon 5501 manual Seat Assembly Instructions, Page, safety switch

SEAT ASSEMBLY INSTRUCTIONS:

12Install all-thread hex head bolts into seat straps.

. Place (1) 5/16-18 x 3" bolt through hole located 1 -5/8" from end of strap. Place (1 ) 5/1 6-1 8 x 4" bolt through hole located 2-7/8" from opposite end of strap. Secure each bolt to strap using (1) 1/8" thick washer and (1) 5/16-18 hex nut w/nylok. See illustration. Repeat procedure for other seat strap.

13Attach seat straps to seat bottom as illustrated.

. The 3" stud protruding through strap must be located near the rear of seat while the 4" stud should be nearest the front edge of seat. Align remaining seat strap holes with holes in bottom of seat as shown, and attach seat straps using

(4) 5/1 6-18X1 " tapping screws.

14Place seat assembly on body, and connect

. safety switch.

15Place (1) seat spacer (1849) on each stud

. protruding through seat bottom, and insert studs through slots in body. Firmly hold seat assembly against body with one hand while body is raised to fully open position. Continue to hold seat against body to prevent damage to seat safety switch wiring.

16Install (1) 5/16 standard flat washer (3020), (1)

. seat knob (3874), and (1) nylok nut (3205) on each of the front studs extending through body and seat frame, and tighten these nuts.

17Install (1) 5/16 standard flat washer (3020) and (1)

. nylok nut (3205) on each of the rear studs. Do not fully tighten these nuts, thus allowing for easy slide action of seat, as provided by knobs on front studs.

Page 8