ASSEMBLY
DRIVE PULLEY
1.Remove the discharge chute from the deck. (Deck configuration will vary by size and model)
2.Lower deck to the lowest cutting position.
3.Remove the right hand (discharge side) belt cover from the deck.
4.Relieve the tension from the deck belt and remove from the center deck pulley.
(See Operator’s Manual if necessary)
5.Remove the nut that secures the right hand deck pulley to the spindle.
6.Install drive pulley included in collection system kit on top of the current deck pulley.
7.Reinstall the nut on the spindle and torque to 55- 75 ft/lbs.
8.Reinstall the deck belt.
Deck Height
Adjustment
Discharge Chute
Belt Cover
Drive Pulley
DECK STOP
1. Locate the deck stop behind the rear lift link on each side of the deck.
2. Set deck stop tube on the deck stop on each side.
Deck Stop Tube
Deck Stop | Lift Link |
10 - Husqvarna
