MAINTENANCE
Adjusting the Mower Deck
WARNING!
Before performing any service or adjustment checklist:
1.Engage the parking brake.
2.Place the Blade switch in the disengaged position.
3.Turn ignition switch to “OFF” position and remove the key.
4.Make sure the blades and all moving parts have completely stopped.
5.Disconnect the spark plug wire from all spark plugs and place the wire where it cannot come in contact with the plug.
Check the tire pressure before adjustment of the mower deck. See “Checking Tire Pressure” in Maintenance section. Faulty mower deck adjustments will cause an uneven mowing result.
Leveling deck
1.Position the mower on a level, preferably concrete, surface.
2.Check the pressure in all four tires. See “Technical Data”.
3.Rotate blades to align front to back.
4.Set the cutting height to 4" (10cm).
5.Measure front blade tip. It should be 4" from ground. If not, turn locknut on top of front L bolt until measurement is achieved. Check blade tip at front on opposite front blade. Adjust locknut on front L bolt as necessary.
6.Check that the rear blade measurement is 4¼" (11.4cm) from ground. If not, turn locknut on top of rear L bolt to achieve measurement. Repeat procedure on opposite side.
Adjusting Cutting Height
1.Raise and secure the deck height lever to the transport position (4½" / 11.5cm).
2.Position blade tip so it is straight forward.
3.Measure from the cutting edge of the blades to a flat level surface. The distance should be 4½" (11.4cm).
4.Drop the level to (for example) the 2" (5cm) cutting height. Measure as above. Distance should be 2".
NOTE: This will place the mower deck in a base measurement position. Additional adjustment may be required to achieve desired cut for the type of grass or conditions being mowed.
WARNING!
Blades are sharp. Protect your hands with gloves and/or wrap blades with a heavy cloth when handling.
3 |
4 |
2 |
1 |
1.Front L bolt
2.Front locknut
3.Rear locknut
4.Rear L bolt
Leveling the mower deck
