CARE AND MAINTENANCE
NEUTRAL ADJUSTMENT:
1.Engage parking brake and raise rear of frame with jack or blocks so that rear tires do not contact the ground.
2.Swing out the control levers, start the engine, and release the paking brake.
3.Raise the upper body to access hydro control linkage. If right wheel creeps, adjust right side linkage and
a.loosen, but do not remove, the bolt in the control tube (5540)
b.loosen jam nuts on ends of the control rod (9067)
c.turn control rod in or out until neutral is achieved
9067 CONTROL ROD ADJUST IN STEP C
d.tighten jam nuts on control rod
e.tighten bolt in control tube
5540 CONTROL
TUBE
JAM NUTS LOOSEN
IN STEP B TIGHTEN IN
STEP D
4. Engage parking brake and lower the body.
Release parking brake and swing control levers in. If wheel creeps, repeat step 3.
5. Stop engine and remove rear of machine from jack or blocks.
CONTROL TUBE BOLT
LOOSEN IN STEP A TIGHTEN IN STEP E
6.Drive machine with both levers in top speed position. If one side now drives slightly faster than the other adjust forward speed bolt in to contact stop sooner.
If levers are now uneven at top speed, loosen control lever mounting nut. Rotate lever to be even with other side and tighten nut.
Page 36
