CARE AND MAINTENANCE
HYDROSTAT DRIVE BELT TENSION ADJUSTMENT
In normal use the hydrostat drive belt tension should be check after the first 20 hours of use for normal wear in and stretch. It may be adjusted as follows:
A.Loosen the idler pulley locking nut until the idler pulley can be just moved relative to the mounting bracket.
B.Tighten the tension adjust bolt until the belt is tight enough to prevent belt slippage. Belt should deflect approximately 3/8" to 5/8" under moderate pressure. Do not over tighten.
NOTE: If belt is over tightened it will often make a "chattering" noise.
C.Retighten the slide locking nut.
Motor Pulley
Tension Adjust Bolt
Hydrostatic
Drive Belt
Idler Pulley
Hydrostatic
Drive Pulley
Cooling Fins
D.Retighten the tension adjust bolt 1/4 turn to set the lockwasher and prevent loosening of the tension adjust bolt.
Page 27
