Dixon ZTR 6023 Tilting the Deck see diagram-page37, Lower & Reattach the DECKsee diagram-page

CARE AND MAINTENANCE

TILTING THE DECK (see diagram-page37)

1.Set the parking brake.

2.Raise the foot deck into vertical position and lock into place.

3.Remove the quick release pin from the anti-buck cylinder at deck end. Lift the cylinder straight up. Use left-hand control lever to hold cylinder in up-right position.

4.Place the deck lift handle in the lowest cutting position.

5.Use lift assist bar, located on left-hand side of deck, inside the deck lift tube.

6.Raise deck lift handle catch, rock handle back and forth until quick release pin pulls free with little effort.

7.Lift up on the front of the deck until deck rotates past 90 degrees. The middle hole on the anti-buck cylinder holder will be in line with the slot on the foot deck locking device. Use the quick release pin to secure the deck in the upright position.

LOWER & REATTACH THE DECK(see diagram-page 37)

1.Rotate the deck back to horizontal position.

2.Stand on front of deck and align deck lift bar with deck lift handle, rock handle back and forth until quick release pin slips through. Note the orientation of the holes in the bar. The first hole is for low cutting 1" to 3", the second hole is for high cutting 3" to 5".

3.Lift the rear corner of the deck until the down hanger engages the push bar. Repeat for other side.

4.Reattach the anti-buck cylinder.

5.Unlatch foot deck locking device and lower the foot deck back to horizontal position.

36