Dixon 17411-1103, ZTR RAM 50 manual Neutral Adjustment, Care & Maintenance

CARE & MAINTENANCE

NEUTRAL ADJUSTMENT

DRIVE MACHINE UNTIL HYDROSTATS HAVE WARMED UP. WITHENGINERUNNINGANDTHEPARKINGBRAKEOFF,SWING OUT THE CONTROL LEVERS. IF MACHINE STARTS TO CREEP, FOLLOWTHEINSTRUCTIONSBELOW.

1.Stop the engine, engage parking brake and raise rear of frame with jack or blocks so that rear tires do not contact the ground.

2.Swing out the control levers, start the engine and release the parking brake.

3.Raise the seat to access hydro control linkage. If right wheel creeps, adjust right side linkage and vice-versa. Use procedure below.

a.Loosen jam nuts on ends of the coupler P/N 7736.

b.If right wheel is creeping forward, turn coupler counter-clockwise until neutral is achieved (clockwise for left side). If right wheel is creeping backward, turn coupler clockwise until neutral is achieved (counter- clockwise for left side).

c.Tighten jam nuts against coupler.

4.Stop engine and remove rear of machine from jack or blocks.

(See Illustration A, page 36)

35