3.2.7 Postal Switch
This programming sequence sets that relay(s) will activate when the postal switch input is activated
on the telephone entry system. The system can be programmed so that only one relay will activate,
or any combination of relays will activate.
Although there are only two relays to set, you will enter a three-digit number in this step. The first
digit will always be 0. To cause a relay to activate, enter a 1 in it's respective character slot, or
enter a zero to not activate the relay. For example, entering 010 in step 3 will cause only relay 1 to
activate. Entering 011 will cause both relay 1 and relay 2 to activate.
Factory setting = 010.
1. Press * 5 0 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the three-digit (1's or 0's only) postal relay code 0 _ _ then press * (beep).
3. Press 0# TOGETHER to end this programming step (beeeeeep).
3.2.8 Touch-tone / Rotary-dial
This programming sequence will set the telephone entry system to dial out in either a touch-tone or
rotary format. Generally, this will be set for touch-tone.
Factory setting = touch-tone.
1. Press * 0 7 and enter the four digit MASTER CODE _ _ _ _ (beep).
2. Enter 0 * (beep) for touch-tone or enter 1 * (beep) for rotary.
3. Press 0# TOGETHER to end this programming step (beeeeeep).
3.2.9 Rotary-dial 9
This programming sequence sets which relay(s) will activate when the system receives a rotary-dial 9
open command from a residents rotary telephone. The system can be programmed so that only one
relay will activate, or any combination of relays will activate.
Although there are only two relays to set, you will enter a three-digit number in this step. The first
digit will always be 0. To cause a relay to activate, enter a 1 in it's respective character slot, or enter
a 0 to not activate the relay. For example, entering 010 in step 3 will cause only relay 1 to activate.
Entering 011 will cause both relay 1 and relay 2 to activate.
Factory setting = 010.
1. Press * 5 1 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the three-digit (1's or 0's only) rotary 9 code 0 _ _ then press * (beep).
3. Press 0# TOGETHER to end this programming step (beeeeeep).
28