3.4.5 Delete Phone Number
This programming sequence is used to delete the phone number under a known directory code.
1. Press * 0 1 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.5.1) then press * (beep).
3. Press # # # # # # # then press * (beep).
4. Press 0 # TOGETHER to end this programming step (beeeeeep).
3.4.6 Delete Area Code
This program sequence deletes the area code programmed into the system.
1. Press * 2 4 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter 1 then press * (beep).
3. Enter # # # # then press * (beep).
4. Press 0 # TOGETHER to end this programming step (beeeeeep).
3.4.7 PBX Line Access Code Programming
If the 1838 / Remote Call Station system is connected to a PBX telephone system rather than a
dedicated C.O. line, you may need to set the unit to dial a line access code prior to dialing the a
phone number. Typically, the line access code is “9”, but check with the PBX system administrator to
be sure.
1. Press * 0 9 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the line access code number _ then press * (beep).
3. Press 0 # TOGETHER to end this programming step (beeeeeep).
NOTE: To change a line access number, enter the correct number in step 2. To
delete a line access number, enter # in step 2.
Page 32 1838-065-L-3-10