signal processing
Storing Programs
User Store
DATA
User Store
Bypassing
NOTE: When you change the selected Parameter from the stored value, a decimal point appears in the bottom right corner of the display and the Store LED lights.
That's it! You can manipulate any effect setting in the FX7 by pressing the associated Effect selector button on the front panel and turning the Data wheel. The Effect Group buttons also toggle the effects on and off with each successive press of the button.
When you're editing Programs, be sure to pay attention to the flashing Status LEDs. This helps you keep track of where you are in the menus.
IMPORTANT: If you want to store your custom Program so you can use it later, follow the procedure below.
The FX7 helps you remember whether or not you've stored the Program you're working on by lighting the Store LED under the bot- tom right corner of the display when the selected Program has been edited.
Remember that if you change any settings in a Program, you have to store the Program into a User memory location. Otherwise, all your changes will be lost.
To store a Program into a memory location:
1)Press the Store button. The Store LED begins flashing and the User LED lights (if not lit already).
2)Use the Data wheel to select the User location where you want to store the Program.
3)Press the Store button again to store the Program in the loca- tion you selected.
After the storing procedure is complete, the FX7 returns to normal operation at the new Program location.
NOTE: Factory Programs can't be overwritten. When you modify a factory Program and store it in memory, the Program is stored in the corresponding number location in the User Program section.
The FX7's bypass functions are very simple.
To bypass individual effects:
1)From Program mode, decide which effect you want to bypass and press its Select button twice. The display reads:
10 | FX7 owner's manual |
