8.2 SPECIFICATIONS
Amplifier section
Continuous average power output of 100 watts∗ per channel, min., at 8 ohms, from 40 Hz to 20,000 Hz with no more than 0.9 %∗∗ total harmonic distortion (front).
Continuous Power Output |
| ||
Front | 100 W + 100 W (1kHz, 0.9 %, 8 Ω) | ||
Center | 100 W (1kHz, 0.9 %, 8 Ω) | ||
Surround | 100 W (1kHz, 0.9 %, 8 Ω) | ||
Input (Sensitivity/Impedance) | 2.8 mV/47 kΩ | ||
PHONO MM |
| ||
CD,....................................................................VCR/TAPE 1, TAPE 2, DVD/LD | 200 mV/47 kΩ | ||
|
| ||
Phono Overload level (T.H.D. 0.1 %, 1kHz) |
| ||
PHONO MM | 100 mV | ||
Frequency Response | 20 Hz to 20,000 Hz ± 0.3 dB | ||
PHONO MM | |||
CD, VCR/TAPE 1, TAPE 2, DVD/LD | |||
................................................... | 5 Hz to 100,000 Hz +0 dB | ||
Output (Level/Impedance) | |||
200 mV/2.2 kΩ | |||
VCR/TAPE 1 REC, TAPE 2 REC | |||
Tone Control |
|
| |
BASS | ± 8 dB (150 Hz) | ||
TREBLE | ± 8 dB (10 kHz) | ||
LOUDNESS | + 8 dB/+ 6 dB (100 Hz/10 kHz) | ||
PHONO MM | 72 dB | ||
CD, VCR/TAPE 1, TAPE 2, DVD/LD | 96 dB | ||
| |||
PHONO MM | 75 dB | ||
CD, VCR/TAPE 1, TAPE 2, DVD/LD | 79 dB |
∗Measured pursuant to the Federal Trade Commission's
Trade Regulation rule on Power Output Claims for Ampli- fier.
∗∗Measured by Audio Spectrum Analyzer.
VIDEO Section
Input (Sensitivity/Impedance) | 1 |
VCR, DVD/LD | |
Output................................................................(Level/Impedance) | 1 |
VCR | |
Frequency Response |
|
VCR, DVD/LD → MONITOR |
|
5 Hz to 7 MHz | |
55 dB | |
Cross Talk | 55 dB |
Manufactured under license from Dolby Laboratories Licensing Corporation. “Dolby”,
FM Tuner Section |
|
|
Frequency Range | 87.5 MHz to 108 MHz | |
Usable Sensitivity | Mono:13.2 dBf, IHF (1.3 µV/75 Ω) | |
50 dB Quieting Sensitivity | Mono: 20.2 dBf | |
|
| Stereo: 38.6 dBf |
Mono: 73 dB (at 85 dBf) | ||
|
| Stereo: 70 dB (at 85 dBf) |
Distortion | Stereo: 0.5 % (1 kHz) | |
Alternate Channel Selectivity | 60 dB (400 kHz) | |
Stereo Separation | 40 dB (1 kHz) | |
Frequency Response | 30 Hz to 15 kHz (±1) dB | |
Antenna Input | 75 Ω unbalanced | |
AM Tuner Section |
|
|
Frequency Range | 530 kHz to 1,700 kHz | |
Sensitivity (IHF, Loop antenna) | 350 µV/m | |
Selectivity | 25 dB | |
50 dB | ||
Antenna | Loop antenna | |
Miscellaneous |
|
|
Power Requirements | AC 120 V, 60 Hz | |
Power Consumption | 210 W | |
In Standby Condition | 5 W | |
AC Outlet |
|
|
SWITCHED | 100 W (0.8 A) MAX | |
Dimensions | 420 (W) × 143 (H) × 325 (D) mm | |
Weight (without package) | ........................ | 7.4 kg (16 lb 5 oz) |
Furnished Parts |
|
|
FM Antenna | 1 | |
AM Loop Antenna | 1 | |
Dry Cell Batteries |
|
|
[size "AA" (IEC R6P)] | 2 | |
Remote Control Unit | 1 | |
Operating Instructions | 1 |
The remote control unit and dry cell battery are not pro- vided with
NOTE:
Specifications and the design are subject to possible modifi- cations without notice, due to improvements.
MAINTENANCE OF EXTERNAL SURFACES
Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the surfaces are very dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleaners.
Never use thinners, benzene, insecticide sprays or other chemicals on or near this unit, since these will corrode surfaces.
49