Fig
D
(Green light)
Blink while
working Connector to charger
Start On
Off
(Red light) Full filter bag indicator
3.4) Replacement of DOLPHIN Battery
During the battery warranty period, call your dealer should you need to replace the battery. After the battery warranty has expired, the battery can be replaced in the following manners:
3.4.1) By contacting your dealer in order to arrange the dispatch of your DOLPHIN to the nearest approved DOLPHIN Service Center.
3.4.2) By contacting your dealer in order to purchase and install Battery Kit on a DIY (Do It Yourself) basis. Battery dismantling and assembly instructions will be enclosed in the Battery Kit.
NB: Discard of used battery in an environmentally friendly manner, which conforms to the prevailing regulations in your country.
Important: Under no circumstance are the battery casings to be opened. This will automatically void the battery's warranty.
3.5) DOLPHIN Installation:
•Ensure that charging cable is disconnected from the float. Insert attached cap to close float's charging socket.
•Place DOLPHIN in pool, gently rock the DOLPHIN from side to side releasing trapped air until the DOLPHIN sinks slowly to the pool bottom [Fig D].
•Press the ‘START’ button on the float switch to start cleaning cycle (see 6 for Automatic shut down). Note that the float is submersible and water tight.
3.6) The Float
Red and green light will blink for a few seconds.
Green light will continue to blink while working.
Red light will blink when filter bag needs cleaning.
Warning! Do not operate the DOLPHIN out of the water. This may result in extensive damage to the pump motor seals, thus invalidating the warranty.
4 ) C l e a n i n g M o d e s
The DOLPHIN dx 5 Battery model offers two modes of operation – Automatic or Remote Control.
The DOLPHIN will work in Automatic Mode unless changed to Remote Control mode, through the Remote Control Unit (R.C.U.)
4.1) Remote Control Mode
In Remote Control Mode, you can maneuver the DOLPHIN to give special attention to a certain area of the pool. Move the Joystick in the direction you desire the DOLPHIN to clean.
Note: If Joystick is not touched for 30 seconds the DOLPHIN will switch back to enter Automatic Cleaning Mode.
The R.C.U. is also used to modify parameters and/or cleaning programs. These parameters have to be transmitted from the R.C.U. to the DOLPHIN while it is working in the pool [see 5
4.2) Automatic Cleaning Mode
In Automatic Cleaning Mode, the DOLPHIN calculates its own cleaning path.
The flow chart in 5.3 represents the factory
Once set, the parameters will remain in the DOLPHIN memory until modified [see 5.1
4
