Dometic 110 Proper Bowl Cleaning, Winterizing, Fig. A, abrasives Comet, Soft Scrub cleansers etc

Models: 210 110

1 8
Download 8 pages 19.46 Kb
Page 4
Image 4
Proper Bowl Cleaning

Proper Bowl Cleaning

For stubborn bowl stains, use SeaLand® Toilet Bowl Cleaner (Fig. A). It’s manufactured especially for use with SeaLand toilets. In certain locations where water is hard, a build-up of lime may dull the toilet bowl finish. Restore the shine with this SeaLand cleaner. If you can- not find it in your area, contact Dometic for your nearest dealer. If the cleaner is not available, you can also use most non-abrasive bathroom and toilet bowl cleaners (Bar Keeper's Friend® spray cleaner, Clorox® toilet bowl cleaner, SaniFlush® toilet bowl cleaner, etc.). Please follow label instructions.

Fig. A

To avoid damaging the Teflon®-coated seal,

Do not use:

abrasives (Comet®, Soft Scrub® cleansers etc.)

caustic chemicals (Drano® clog remover, etc.)

lubricants and cleaners containing alcohols or petroleum distillates (Pam® cooking spray, Pine-Sol®cleaner, WD-40®lubricant, etc.).

®Bar Keepers Friend is a registered trademark of SerVaas Laboratories Inc.

®Clorox, Pine-Sol and Soft Scrub are registered trademarks of The Clorox Co.

®Comet is a registered trademark of Prestige Brands International.

®Drano is a registered trademark of S.C. Johnson & Son Inc.

®Pam is a registered trademark of ConAgra Foods.

®Sani-Flush is a registered trademark of Reckitt Benckiser Inc.

®Teflon is a registered trademark of DuPont Co.

®WD-40 is a registered trademark of WD-40 Company.

Winterizing

At the end of each season, the SeaLand toilet should be winterized for storage by either draining or using potable water-safe antifreeze in the system.

To drain:

1.Thoroughly flush system with fresh water.

2.Empty holding tank.

3.Shut off water supply to toilet, and remove inlet waterline (Fig. B).

Do not remove brass cap on bottom of valve.

4.Press flush lever until all water is drained from toilet.

To use antifreeze:

1.Drain potable water tank.

2.Add freshwater antifreeze to potable water tank.

Fig. B

3.Flush potable water antifreeze and water mixture through toilet and into the waste holding tank. Each installation is different, so amounts may vary. User discretion is required to assure adequate protection.

4.Empty holding tank.

NOTE: Use nontoxic antifreeze designated for potable water systems. (See vehicle owner’s manual.) Never use automotive-type antifreeze in freshwater systems.

Page 4
Image 4
Dometic 110, 210 Proper Bowl Cleaning, Winterizing, Fig. A, To avoid damaging the Teflon-coated seal Do not use, To drain