Dometic 3200 Series owner manual

STEP 9: WITH THE ELECTRICAL POWER OFF, route #14 gauge stranded copper wire from 12 VDC ground and positive 12 VDC from the fuse panel through a 2-amp fuse or circuit breaker. Leave at least 12 inches (305 mm) of wire for connecting to toilet (fig. 9).

Fig. 9

STEP 10: Connect the holding tank to the bottom of the discharge flange.

STEP 11: Slide the four T-bolts into the slots of the floor flange. Install the flange gasket over the T-bolts (fig. 10).

Fig. 10

STEP 12: Install floor flange adapter with words “THIS SIDE UP” facing up. Tighten adapter to floor flange using four flat washers and hex nuts. Tighten in criss-cross pattern (fig. 11).

Fig. 11

IMPORTANT: If replacing an existing toilet with 2-bolt floor flange, drill two 5/16-inch dia. holes in old floor flange that align with two additional holes in floor flange adapter. Use two #10 or 12 x 1-1/2-inch wood screws and washers for these drilled holes, and two T-bolts with flat washers and nuts to fasten flange gasket and floor flange adapter to old floor flange. Do not use old hardware or seal.

STEP 13: Temporarily set the toilet in place on the floor flange (fig. 14).

Fig. 14

STEP 14: Mark the holes for the two toilet mounting bolts (fig. 15).

Fig. 15

STEP 15: Pick up toilet and set aside. Drill 3/16-inch pilot holes in the floor (fig. 16).

Fig. 16

STEP 16: With toilet close to floor flange, connect flex- ible water supply hose to the water line fitting (fig. 17).

Fig. 17