3308120.XXX GENESIS AIR FILTRATION SYSTEM
5.The
C.AIR DISTRIBUTION DUCT INSTALLATION
Install the air distribution ducts in the RV roof cavity. The distribution system must meet:
1.RV’s requirements
2.System requirements listed in Section 3 of this Manual. Terminate the start of the duct at the back edge of the
FIG. 2 |
| TOP VIEW |
|
|
|
| (BACK OF RV) |
|
|
|
| FRAME |
|
|
| DUCT |
|
| |
| OPENING | DUCT |
| |
FRAME |
|
|
| |
|
|
|
| |
|
| AC POWER |
|
|
|
| SUPPLY WIRE |
|
|
|
| FRAME |
|
|
LOW VOLTAGE WIRES: | CCC, CONTROL CABLE(S) | |||
12VDC |
| or |
| |
Furnace |
|
|
|
|
Load Shed |
|
|
|
|
Sensors |
| SIDE VIEW |
|
|
|
|
|
| |
ROOF | (TOWARD BACK OF RV) |
| DUCT | |
INSULATION |
|
|
|
D.Place the Genesis Air Filtration System and System Control Option inside the RV. These boxes contains mounting hardware for the air conditioner/heat pump and will be used inside the RV.
6. INSTALLATION OF UNIT
A.Take the Genesis Air Filtration System from the carton.
B.If the Controls are not part of the unit. Position the electrical box towards the front of the opening with all of the system control wires connected to the control box
except for the DC power. See figure 3.
FIG. 3 | Wires Connected To | |
Control Box | ||
| ||
| Control | |
| Box |
Vehicle
FrontBase
Pan
C.Locate the foam divider and insert it corner to corner in the
NOTE: If using center duct installation See Step
| OPENING |
|
DUCT | CEILING | INSULATION |
|
|
5. PLACING THE UNIT ON THE ROOF
A.Remove the air conditioner/heat pump from the carton.
B.Place the air conditioner/heat pump on the roof.
!WARNING
This unit weighs approximately 100 pounds. To prevent back injury, use a mechanical
FIG. 4 |
|
Upside | Base Pan |
Down |
|
Foam |
|
Divider |
|
Place Foam Divider in
Do not Peel Tape Off Foam Divider
Ceiling
Foam Divider Ceiling
Level (±1/4") Tear Off
Excess
hoist to place air conditioner/heat pump on roof.
C.Lift and place the unit over the prepared opening using the gasket on unit as a guide. The roof gasket on the bottom of the base pan goes toward the front of the RV. Sliding the unit on the roof will damage the roof gasket.
CAUTION
Do not slide the unit. This may damage the neoprene gasket attached to the bottom and create a leaky installation.
Note: If center duct system is being used, be sure to install duct adapter to the bottom of the base pan, before unit is placed over opening. Duct adapter 3100342.XXX and 3100262.XXX can be used. Alternate methods of duct connection are available for installation; however, they must be approved in writing by Dometic.
1. Center Duct Installation (Penguin 620 & 630 Series Only)
a. See Step B.
b. Cut notch in the center section of the foam divider to fit duct (approximately 8 x 2 inches) . See figure 5.
FIG. 5 | Foam |
Tape Covered | Divider |
| |
Adhesive |
|
| Mark And Cut 8 x 2” |
| Opening For Center |
| Duct |
6