CENTRAL RV VACUUM
SPECIFICATIONS:
Electrical Rating | 240VAC 50/60 Hz, 1 Ph |
|
|
Amp Draw | 11 Amps |
|
|
Minimum Wire Size | 16 AWG |
|
|
AC Circuit Protection | 7.5 Amp |
|
|
Installed Weight | 12 Lbs. |
|
|
Hose Length | 8’ - 30’ |
Case | Steel |
| powder coat |
Part List:
(1) Mounting Bracket* | ||
(4) Wood Screws* | (3) 3308150.006 Bags | |
(4) | Painted Screws** | (1) 3308172.000 Motor Filter |
(1) | Template** | (1) 3303170.004 Exhaust Filter |
|
| (3) Wire Nuts** |
MODEL NUMBER CODE CHART
1 = Flush Mount
2 = External Mount
W/Mtg Brkt
C = CREAM
E = EBONY
W = WHITE
P = POWDER COAT
R = RECREATION VEHICLE
Tools Required: |
|
Screw Driver | Power Drill |
Level | Electrical Wire |
1/16” Drill Bit | Drywall Anchors |
Awl |
|
*Designates supplied with external mount vacuum.
**Designates supplied with flush mount vacuum.
INSTALLATION
I. GENERAL INFORMATION
A.This Central RV Vacuum Cleaner is designed to be built into a recreational vehicle at the time of manufacture; or, with the use of an external mounting plate, it can be installed in a recreational vehicle after it has been manu- factured.
Read Installation and Operating Instructions carefully before attempting to start your vacuum cleaner installa- tion.
!WARNING
Improper installation may damage equip- ment, could endanger life, cause serious in- jury and/or property damage.
B.LOCATION:
1.External Mount Installation
a.To reach with vacuum hose as far as possible, choose a wall or surface that is centrally located and has an electrical outlet within 6 foot of vacuum cleaner.
Attach mounting bracket to wall or surface at a comfortable operating height or if not possible a minimum of 6” above the floor. For hard surface mounting, use the 4 outer holes with wood screws. For drywall mounting, use 4 outer holes with dry- wall anchors (not supplied). See FIG. 1.
INSTALL MOUNTING
BRACKET WITH
SCREW HOLES
ABOVE KEYSTUDS
KEYSTUD |
| |
FIG. 1 | 6” MIN | |
CLEARANCE | ||
|
c.Attach vacuum cleaner to the mounting bracket, using the 4 keyholes in the back of the unit to the 4 studs on the mounting bracket, then slide unit down into locked position.
d.Before plugging in the electrical cord, check to be sure vacuum cleaner bag, motor filter, ex- haust filter, and gate are in place. See Oper- ating Instructions, Steps D, E, and F.
Note: Never use vacuum cleaner without dust bag or motor filter in place.
3