TROUBLESHOOTING
The Refrigerator Does Not Cool Properly
A.Burner jet clogged.
Clean. (See Section Maintenance & Service, item 2. Periodic maintenance, Paragraph E item
B.Check level of refrigerator.
C.Venting problem.
Restriction in air flow across cooling unit.
D.Heavy frost buildup on evaporator fins. Defrost.
E.Flue baffle not inserted properly in flue tube.
F.Improperly set thermostat.
See section Operating Instructions, part Start Up Instructions.
G.Burner dirty.
Clean. (See section Maintenance & Service, item 2. Periodic Maintenance, Paragraph E item
H.LP gas pressure low at burner.
Set main regulator so pressure does not drop below 11 inches of water column at pressure test port. (See FIG. 12).
I.Burner not located properly under flue tube. Relocate.
J.Burner damaged. Replace.
K.Odor from fumes.
1.Dislocated burner
2.Damaged burner
3.Dirty flue tube
L.FUSES
1.Refrigerator control system
2.Refrigerator AC Supply
See page 12, part FUSES.
If the refrigerator fails to work, check the following points before calling a service technician:
•that the fuses are intact
•that the power cord is plugged in
•that 12 volt DC is connected to the refrigerator
The refrigerator is equipped with an overheating protec- tion.
An authorized service technician can check if it has been triggered or not.
NOTE: AVOID SPRAYING WATER THROUGH THE REFRIGERATOR VENTS WHILE WASHING YOUR RV.
All the above instructions are to be followed closely. The refrigerator is
CHANGING DOOR HINGES FROM ONE SIDE TO THE OTHER
The refrigerator is equipped with convertible doors. To change the door swing, consult the parts manual for the Conversion Kit Number. For further information, please contact Dometic Corporation listed on the front page.
INSTRUCTIONS FOR MOUNTING THE DOOR PANEL
The refrigerator is normally delivered without door pan- els. Before starting the mounting work, check that the panel dimensions are in compliance with those given in the table and the instructions are read thoroughly.
When mounting the panel, proceed as follows: See figure page 15.
A.Open the door 90 degrees.
On new refrigerators, the decoration strips are taped inside the door; if installed on the door, remove the door decoration strip (2) by removing its three screws (1).
B.Insert the vertical edges into the grooves of the door frame (3).
C.Push the panel downward so that the lower hori- zontal edge of the panel (4) is fitted into the bottom grove (5).
D.Put the decoration strip across the door so that the gap is covered. Secure the decoration strip with the three screws removed in Step A (1).
14